Link-systems OmniLink 5000 Manual do Utilizador descarregar pdf (Página 96)

7.4

The mounting dimensions for all available assemblies are shown in Figure 7.5.

Figure 7.5 Card Rack and Output Power Supply

Mounting Dimensions

The mounting dimensions for the resolver/encoder assembly are shown in Figure 7.6. When the

resolver/encoder is driven by a chain, the spring base should be used. The resolver/encoder assembly

mounted on the spring base is shown in Figure 7.7. The shaft of the resolver/encoder is 3/4 " in diameter

with a 3/16 " wide keyway. The sprocket attached to the resolver/encoder must be bored and keyed to

fit. Do not install the sprocket without a proper size key. After installing sprocket and key, the clip ring

must be installed in the groove on the end of the resolver shaft.

Figure 7.6 Resolver/Encoder Mounting

Dimensions

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 114 115

Sem comentários

Link-systems OmniLink 5000 Manual do Utilizador Página 96