Link-systems OmniLink 5000 Manual do Utilizador descarregar pdf (Página 26)

4.8

Group 5 Programmed in Factory Mode Configuration.

45 Allow Timed Inch (value)

46 Allow Auto Single Stroke (value)

47 Allow Continuous on Demand (value)

48 Allow Maintain Continuous (value)

49 Maximum Auto Single Stroke time (value)

50 Max. Continuous on Demand time (value)

Section 4.2.9.4 Event Log

The controls retains a event log. This log records the reason for the last 128 stops. All reasons for last stop

are recorded, except automatic stop on top. Each entry in the event log contains the time, date, and the type

of stop. The event log is illustrated in Figure 4.4. Stops are displayed in chronological order with the most

recent stop displayed first. The “Next Page” and “Previous Page” softkeys can be used to scroll through the

event log.

Stroke

Mode

Sin

le Stroke

Drive

Speed

Stroke

Speed

SPM

Order

Counter

PC STATUS

Counter OFF

EVENT

LOG

EXIT

READY TO STROKE

TOP

PAGE

Date TimeSubs

stem

------------------ ------------------- -------------------------------------

3/21/2000 14:59:41 Event Lo

Subs

stem

Reason: To

Sto

3/21/2000 14:59:02 Event Lo

Subs

stem

Reason: Li

ht Curtain # 1

3/21/2000 14:50:49 Event Lo

Subs

stem

Reason: Die Block

3/21/2000 14:49:22 Event Lo

Subs

stem

Reason: Auxiliar

Sto

3/21/2000 14:44:18 Event Lo

Subs

stem

Reason: To

Sto

3/21/2000 14:42:29 Event Lo

Subs

stem

Reason: To

Sto

3/21/2000 14:38:48 Event Lo

Subs

stem

Reason: To

Sto

3/21/2000 14:32:59 Event Lo

Subs

stem

Reason: To

Sto

Figure 4.4 Event Log

Section 4.2.9.5 Version Information

The version information of the control hardware and software can be viewed by depressing the VERSION

INFO. softkey.

Section 4.2.10 RESET ERROR

The press control screen alerts the operator of an error condition by displaying a RESET ERROR softkey

as shown in Figure 4.5. The reason for the error is shown under Present Running Status. The press can not

be operated until the error is corrected and an operator acknowledges the error by pressing the RESET

ERROR softkey. See the section on Troubleshooting for conditions that require an operator's response.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 114 115

Comentários a estes Manuais

Sem comentários

Link-systems OmniLink 5000 Manual do Utilizador Página 26

Comentários a estes Manuais

Manuais e produtos relacionados com Instrumentos de medida Link-systems OmniLink 5000