Link-systems OmniLink 5000 Manual do Utilizador descarregar pdf (Página 20)

4.2

6. The status of the order and batch counter. This includes the preset limit, the present quantity

produced, and the on/off state of the counter.

7. A bar graph which represents the current main motor speed.

8. A bar graph which represents the current main motor load.

Section 4.2 Press Control Menu

Figure 4.2 shows the Press Control Menu. This screen provides detailed information about the press, the

press control, and auxiliary equipment. The softkeys shown active in the PROG mode indicate parameters

that can be changed.

Stroke

Mode

Sin

le Stroke

Drive

Speed

Stroke

Speed

SPM

Order

Counter

PC STATUS

Counter OFF

PRESS

CONTROL

CHANGE

NUMBER

MOTOR

SPEED

TONNAGE

MONITOR

AUTO

SETS

DIE

PROTECTION

EXIT

SPM

% LOAD

161

READY TO STROKE

TOP

AUXILIARY

COMM.

DIAGNOS

OPERATOR

STATON

Brake Monitor Limit Stoptime

Top Stroke Stop 0200 183 mSec

Mid Stroke Stop 0250 0 mSec

Clutch time 0275 0250 mSec

Limit Actual

Auto Single Stroke Time ……… 5 Sec

Feed Complete Position ……… 25 Degs

Cont. on Demand Time ……….10 Mins

Auxiliary Equipment Message

Option is not Installed

Reason for the Last Stop

Power Up

Present Running Status

Ready to Stroke

Figure 4.2 Press Control Menu

The display provides the following information:

1. A brake monitor used when the press stops at the top of the stroke.

2. A brake monitor used when the press stops at any position other than top.

3. The actual stopping time of the press, measured by the brake monitor.

4. Clutch engagement time.

5. Auto Single Stroke Time

6. Feed Complete Position

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 114 115

Comentários a estes Manuais

Sem comentários

Link-systems OmniLink 5000 Manual do Utilizador Página 20

Comentários a estes Manuais

Manuais e produtos relacionados com Instrumentos de medida Link-systems OmniLink 5000