Link-systems OmniLink 5000 Manual do Utilizador descarregar pdf (Página 25)

4.7

Group 2 Programmed in Top Stop Calibration (configuration).

06 Speed Range (lowest)

07 Stop position (in single stroke)

08 Stop position (in continuous)

09 Speed Range (1/3 range)

10 Stop position (in single stroke)

11 Stop position (in continuous)

12 Speed Range (2/3 range)

13 Stop position (in single stroke)

14 Stop position (in continuous)

15 Speed Range (highest)

16 Stop position (in single stroke)

17 Stop position (in continuous)

18 Stop position in setup/stop time mode

Group 3 Programmed in Machine Parameters (configuration).

19 Resolver/encoder offset

20 Automatic carry up position

21 Begin timed inch position

22 Minimum strokes/min

23 Maximum strokes/min

24 Motion filter

25 Clutch engagement time

26 Timed inch pulse duration

27 Automatic turn off time

28 Maximum # Engagements/Minute

Group 4 Programmed in Factory Configuration Machine Parameters.

29 Hydraulic Overload type (value)

30 Inch Button Config (value)

31 Input configuration (value)

32 Output configuration (value)

33 Tonnage monitor type (value)

34 Die protection type (value)

35 Automatic Setups (value)

36 Light curtain mute type (value)

37 Feed line type (value)

38 Valve monitor type (value)

39 Valve monitor pull in time (value/10)

40 Valve monitor drop out time (value/10)

41 Valve monitor track time (value/10)

42 Main motor delayed turn on time (value)

43 Main motor delayed turn off time (value)

44 Reserved Factory parameter (value)

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 114 115

Comentários a estes Manuais

Sem comentários

Link-systems OmniLink 5000 Manual do Utilizador Página 25

Comentários a estes Manuais

Manuais e produtos relacionados com Instrumentos de medida Link-systems OmniLink 5000