Link-systems OmniLink 5000 Manual do Utilizador descarregar pdf (Página 3)

TABLE OF CONTENTS

Section 1 Introduction to the System 5000 Die Protection Module .................. 1-1

Section 1.1 Features ................................................... 1-1

Section 2 Operation ......................................................... 2-1

Section 2.1 Main Menu Status Block ...................................... 2-1

Section 2.2 Die Protection Menu ......................................... 2-1

Section 2.3 Access Control .............................................. 2-2

Section 2.3.1 Key Only Mode ...................................... 2-2

Section 2.3.2 Key or Password Mode ................................ 2-2

Section 2.3.3 Password Only Mode ................................. 2-3

Section 2.3.4 Key and Password Mode .............................. 2-3

Section 2.3.5 Die Protection Restricted Items ......................... 2-3

Section 2.3.6 Access Control Operation .............................. 2-4

Section 2.3.6.1 Program/Run Key Switch Operation .............. 2-4

Section 2.3.6.2 Password System Operation .................... 2-4

Section 2.4 Type of Sensor .............................................. 2-6

Section 2.4.1 Programming Input Type ............................... 2-7

Section 2.5 Input Description ............................................ 2-7

Section 2.6 Input Status ................................................ 2-9

Section 2.7 Input State ................................................ 2-10

Section 2.8 RESET ERRORS key ....................................... 2-10

Section 2.9 BYPASS ON/OFF key ...................................... 2-10

Section 2.10 View Channel Information ................................... 2-11

Section 2.10.1 Changing Channel Information ........................ 2-11

Section 2.10.2 Programming Stop Output ........................... 2-12

Section 2.10.3 Programming Delay Time ............................ 2-12

Section 2.10.4 Programming Window Setpoints ...................... 2-13

Section 2.10.5 Programming Separation Time ........................ 2-13

Section 2.10.6 Programming Track Channel ......................... 2-13

Section 2.10.7 Programming Track Time ............................ 2-14

Section 2.11 Input Capture Capability .................................... 2-14

Section 2.12 Programmable Limit Switch Menu ............................ 2-15

Section 2.13 Job Setups ............................................... 2-16

Section 3 Die Protection Input Types and Their Uses ............................. 3-1

Section 3.1 Static N.O. and Static N.C. .................................... 3-1

Section 3.2 Cyclic ..................................................... 3-2

Section 3.3 Transfer ................................................... 3-3

Section 3.4 In Position ................................................. 3-4

Section 3.5 1 Part Detector-Edge and 1 Part Detector-Pass ..................... 3-5

1 2 3 4 5 6 7 8 ... 38 39

Sem comentários

Link-systems OmniLink 5000 Manual do Utilizador Página 3